09-28-2016, 07:57 AM
09-28-2016, 10:52 AM
Are you talking bathroom or kitchen sinks? If kitchen is your's an integral part of the countertop?
09-28-2016, 12:19 PM
Mike's coach is #372, a 1995 model. The interior photo I have shows two round kitchen sinks which were likely molded into the counter top as they are on my 1992. I also had that type sink in the house and I was going to have the house kitchen sink refinished by the same company that I hired to refinish my corian counter tops but he found a large crack all the way through the corian sink that was starting to leak water. As a result, I had him cut the sink out and I installed an over the counter mounted sink.
It is isn't cracked, I would go the refinishing route. Trying to cut corian sinks out and install another under mount sink might be possible but it would be concerned about getting a clean enough cut to seal a new under mount sink adequately, especially without removing the entire counter top. Your mileage may vary.
It is isn't cracked, I would go the refinishing route. Trying to cut corian sinks out and install another under mount sink might be possible but it would be concerned about getting a clean enough cut to seal a new under mount sink adequately, especially without removing the entire counter top. Your mileage may vary.
09-29-2016, 06:34 AM
I have a single undermount sink in my 93 kitchen. It was not difficult to remove. It is not integral to the counter and is cast iron based.
09-29-2016, 06:56 PM
My two sinks are like jons. Corian countertop with detachable cast with a porcelain finish. My sinks have no splits or cracks, just chipped from wear and tear. Trying to find one is more than likely imposible to find, so if I am carefull removing the units refinishing is likely the way to go.
09-29-2016, 07:52 PM
my kitchen sink is corian. my bathrooms sinks are cast iron undermount
tom
tom
09-30-2016, 01:32 PM
I found a guy in Illinois that could apply new porcelain for about 450 dollars.
I also found a bar sink in stainless that was only slightly larger diameter.
I didn't keep any records of this seach so I can't point any further than this.
I also found a bar sink in stainless that was only slightly larger diameter.
I didn't keep any records of this seach so I can't point any further than this.