01-13-2019, 05:27 AM
Pages: 1 2
01-13-2019, 10:11 PM
Yes great job. I've had 18 custom aluminum fuel tanks made the last few years for gas, diesel, flex fuels, avgas, jet fuel etc. I used this company for several parts including some custom machined TTMA, blind tapped flanges and the quality was always excellent.
https://www.fueltankparts.com/fuel-tank-...ories.html
I would recommend using aluminum sheeting thicker than 1/8". I used 3/16" and haven't had any problems, but had some failures with 1/8" material. With our stainless steel tanks 1/8" material has worked fine.
https://www.fueltankparts.com/fuel-tank-...ories.html
I would recommend using aluminum sheeting thicker than 1/8". I used 3/16" and haven't had any problems, but had some failures with 1/8" material. With our stainless steel tanks 1/8" material has worked fine.
01-14-2019, 06:03 AM
Great Link !
And right around the corner from me, too.
And right around the corner from me, too.
02-11-2019, 05:04 AM
Excellent job and write up. That's one good looking tank.
Pages: 1 2