RE: bottom of slide sticking out after sitting -
Fulltiming - 05-15-2015
Larry, I think the bottom of the slide could creep out some even with the top slide locking pins engaged. The concern then would be if the torque was enough to shear the locking pins.
RE: bottom of slide sticking out after sitting -
lbrachfe - 05-15-2015
Didn't know that could happen Michael. Good to know
RE: bottom of slide sticking out after sitting -
encantotom - 05-15-2015
yes, when i first noticed it, the bottom was sticking out about and inch and the top was pinned in with the slide locks.
tom
RE: bottom of slide sticking out after sitting -
encantotom - 08-22-2015
The extend solenoid replacement seems to have fixed the creep. The have been in for about a month or so with no creep
Tom
RE: bottom of slide sticking out after sitting -
smagown - 08-23-2015
Tom did you mean the extend solenoid? "Extract" sounds like something Larry drinks.
RE: bottom of slide sticking out after sitting -
encantotom - 08-23-2015
Yes Steve I edited my y post to say extend thanks
Tom
RE: bottom of slide sticking out after sitting -
lbrachfe - 08-23-2015
How did you know Steve that I have a can of "Extract" every morning. Keeps me regular ! HA... Hope everything is good in Monroe........
RE: bottom of slide sticking out after sitting -
smagown - 08-23-2015
Miss all you folks!!
RE: bottom of slide sticking out after sitting -
cfree3 - 09-27-2016
We have the opposite problem with our bedroom slide. When we bring it in the top of the slide comes in about 3/4 inch further than it should and the pins don't lock. The bottom comes in just right. Water then can get in when going down the road in heavy rain because the seal is not sealed in the right place.
Anyone had this problem and how did they solve it?
RE: bottom of slide sticking out after sitting -
jlbagley - 05-27-2019
Hello. I have a 2003 #642, Newell and I noticed the rear slide is creeping out at the bottom. Since your repair 4 years ago, do you have anything additional to add? I will start looking at replacing the extend solenoid. Thank you.