generator Slide-out Valve - Printable Version
+- Newell Gurus (
https://newellgurus.com)
+-- Forum: Technical Discussions (
https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Air Operated Systems and Leaks (
https://newellgurus.com/forumdisplay.php?fid=33)
+--- Thread: generator Slide-out Valve (
/showthread.php?tid=2231)
generator Slide-out Valve -
77newell - 04-08-2015
It appears the push-pull control valve for the generator slide-out has died. Has anyone replaced theirs and knows a source for a replacement?
RE: generator Slide-out Valve -
Richard - 04-09-2015
Jon, if you google three way two position pneumatic valve you will see they are very common. I got mine from amazon. I took mine apart in an attempt to rebuild. It doesn't really have o rings on the shaft. Instead it has rubber disks which made it tough to fix with what I coud find.
RE: generator Slide-out Valve -
77newell - 04-09-2015
Richard: thanks for the info. I had looked at the valves on Amazon and the valves I found there were rated for pressure up to 116psi. Since my coach will go to 125psi at compressor shut-off I was concerned that those valves might not last too long. Perhaps you have found that is not the case.
I did find that Motion Industries has a valve rated to 140psi. It's more expensive; $53 versus $34 or so for the lower pressure rated valves.
RE: generator Slide-out Valve -
77newell - 04-22-2015
Velvac P/N 320121 rated for 145psi was what I went with at about $60.00 from Fleetpride locally.