Everyone check - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: General and or Other Stuff (https://newellgurus.com/forumdisplay.php?fid=16)
+--- Forum: General (https://newellgurus.com/forumdisplay.php?fid=21)
+--- Thread: Everyone check (/showthread.php?tid=2322)

---

Everyone check - Yachts - 05-28-2015

Yesterday I went to open the engine door on the rear of the coach and the cable that runs to each of the latches that you pull down to release broke.  It is a SOB to have to get the latches to release if it breaks.. Everyone check theirs and if it's worn replace it.

---

RE: Everyone check - bikestuff - 05-28-2015

Good thought, Marc!

I have been redoing the cables that keep my basement doors from swinging too far out....but never thought about the cables that attach to the latches. Will probably replace for general purposes!

Thanks!

---

RE: Everyone check - Yachts - 05-28-2015

5$ at lowes and 5 mins work

---

RE: Everyone check - rheavn - 05-28-2015

Lubricate all the latches regularly and you'll take a lot of wear off the cables.

---

RE: Everyone check - Yachts - 05-28-2015

I prolly should hit them with some wd 40

---

RE: Everyone check - Richard - 05-29-2015

WD 40 is NOT a lubricant. It pulls the lube out of whatever you spray it in. WD is water displacing. Not being a know it all, just use a spray lube and not wd 40.

---

RE: Everyone check - Yachts - 05-29-2015

Thank you Richard. I will not use wd 40.. How is Newell?

---

RE: Everyone check - MARKGMC3 - 06-26-2015

I always though this was going to happen every time i opened the engine cover.  

So i drilled a 1/4" hole in the cover just opposite the latch arm on each side.  Now i can use a phillips head screwdriver or similar to open the latch if the cable breaks.

installed a small plug........ Looks like the engine cover came that way.

---

RE: Everyone check - Sundance - 06-28-2015

(06-26-2015, 01:26 PM)MARK FINCKE Wrote:  I always though this was going to happen every time i opened the engine cover.  

So i drilled a 1/4" hole in the cover just opposite the latch arm on each side.  Now i can use a phillips head screwdriver or similar to open the latch if the cable breaks.

installed a small plug........ Looks like the engine cover came that way.

Great fix, please post pictures.
Thanks 

---

RE: Everyone check - MARKGMC3 - 07-08-2015

hi,

some pics of mod on engine cover ..so u can still open it..if one of the cables gets disconnected......

---