You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Engine cover gas springs - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Parts is parts (https://newellgurus.com/forumdisplay.php?fid=28)
+--- Forum: Replacement part information (https://newellgurus.com/forumdisplay.php?fid=68)
+--- Thread: Engine cover gas springs (/showthread.php?tid=2388)



Engine cover gas springs - rheavn - 07-06-2015

These are the four gas springs used to hold up the rear engine cover on my coach.  Not sure how many years these parts will be the same.  The link includes all measurements needed to verify if they will work on your year Newell.

http://www.asraymond.com/gas-struts.html?cid=ha-standard&id=GSNI3100150


RE: Engine cover gas springs - Chester Stone - 07-06-2015

I had to make a special clamp tool to compress the springs in order to replace them.


RE: Engine cover gas springs - wjshed - 08-03-2015

(07-06-2015, 05:02 PM)Chester Stone Wrote:  I had to make a special clamp tool to compress the springs in order to replace them.

I'm hoping to be able to use a ratchet strap wrapped around the length of the strut with the ends of the strapped hooked together. Just ordered them. I'll update after I install them.


RE: Engine cover gas springs - Mxfarm - 08-03-2015

Your strap will need to 'slide' around the ends of the strut as it tightens - depending on the strap it might not want to slide easily.


RE: Engine cover gas springs - wjshed - 08-10-2015

It took a few tries to get the right technique down, but the ratchet strap method works. I put the strap around the strut with one end of the strut on the ground so I could push down on it with my weight while also ratcheting the strap. You have to watch the strap closely where it is sliding over the ends of the strut b/c it wants to slide off the side. Those were the correct struts for my '95.
Thanks for the help.


RE: Engine cover gas springs - rheavn - 07-28-2018

Here is the thread that explains the tool that makes installation easy.

http://newellgurus.com/showthread.php?tid=453