HWH Slide Bearing Pads - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Slides (https://newellgurus.com/forumdisplay.php?fid=55)
+--- Thread: HWH Slide Bearing Pads (/showthread.php?tid=3847)

---

HWH Slide Bearing Pads - Richard - 11-03-2017

Have any of you ever replaced the Nylon/Delrin pads that the slide rides on? 

I found one reference where @"RussWhite" said one had to be replaced. 

I have two questions. Do you have a part number from HWH? And more importantly, does the room have to come out for the pad to be replaced? That's the biggie.

I noticed my salon side trim was not lining up on one end. Hmmm, investigation shows the pad is worn thinner on that end. Makes sense on the trim not lining up now. Not sure if it's worth taking the room out to fix an aesthetic. 

No, I haven't called Newell. It's early in the morning

---

RE: HWH Slide Bearing Pads - RussWhite - 11-03-2017

As of June 2015 - "the kit you need will be an RAP91342 and it will cost you $19.86 per kit plus freight. Each kit will have 10 of the pads you are looking for."

The slide was pulled out and all the pads replaced. There are about 32 pads total. I suppose you could use something else other than going to HWH, but I didn't.

Russ

---

RE: HWH Slide Bearing Pads - Richard - 11-04-2017

Thank you Russ. I looked for an hour at the HWH site, used their search engines, and came up with nothing.

I'll get one on order. Sometimes looking at the new part gives insight into how the old one is mounted.

---