RE: Engine does not turnover -
rheavn - 07-02-2018
"I think 24037 is the one I will use."
Did you install the new starter solenoid? All is well?
RE: Engine does not turnover -
rheavn - 07-27-2018
Hello Richard
RE: Engine does not turnover -
Richard - 07-27-2018
Yes. Installed that part number. In Canada with very limited interweb access. All is well with starting.
RE: Engine does not turnover -
Joe Galowitch - 10-13-2019
Ok Gurus here is another no crank problem. New battery’s but is has been sitting forever so we charged batteries good load test but no crank. Tried starting from rear still no crank. Able to start with remote jumper starts fine.there doesn’t seem to be juice at the relay. I will check for a neutral relay but indicator shows neutral.
RE: Engine does not turnover -
encantotom - 10-13-2019
start with a voltmeter at the starter and work your way back.
another thing that happened to me once is one of the big fuses on the battery was blown. so each battery showed good but no start.
is there power at the merge relay on both sides?
just break it into chunks and test each chunk.
tom
RE: Engine does not turnover -
Joe Galowitch - 10-13-2019
Ok will do I will check merge solenoid, which was a god thing as we we’re poking around we found that one post was about 1 turn from falling off. That would have been a fire for sure. Anyhow thanks I will get busy soon.
RE: Engine does not turnover -
Joe Galowitch - 10-15-2019
Thanks to the guys at Newell we have the problem fixed. It turns out the toggle switch in the rear for the run was bad, it seems to be a common problem so now I know.