You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Air govenor - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Parts is parts (https://newellgurus.com/forumdisplay.php?fid=28)
+--- Forum: Replacement part information (https://newellgurus.com/forumdisplay.php?fid=68)
+--- Thread: Air govenor (/showthread.php?tid=4371)



Air govenor - rheavn - 07-15-2018

Bendix part #275707N appears to be the original d-2 governor on the DD series 60 engine.  It has a pressure range of 105 psi to 125 psi.

There are many other ones manufactured by companies other than Bendix.  Such as:

https://www.amazon.com/Truck-Governor-Bendix-Midland-Freightliner/dp/B005458FYY

https://www.napaonline.com/en/p/MBI275491RX

https://www.oreillyauto.com/detail/b/brakebest-hd-2911/agriculture-hd-parts---accessories-19818/fleet---heavy-duty-20088/air-brake-compressor-valves---products-20110/hd-truck-air-brake-compressors--tanks---products-20246/2596cb252ece/brakebest-hd-governor/rb18530/2543649

There are many more and any truck repair shop should be able to provide one. 

Here is an article on adjusting the air governor:

https://www.mechanicshub.com/toolbox/adjusting-bendix-air-governor/

There are several YouTube videos on how to change one, including the one Mike Ginn posted:

https://www.youtube.com/watch?v=gavC4ZWSNLY

Tip:  When changing one on a Newell you have to shut off all air compressor(s) and drain all the air from the supply system.  When the "supply" gauge on your dash reads zero you are good to start the replacement.

Hope this helps someone.............................................


RE: Air govenor - encantotom - 07-15-2018

can you see any reason to spend 50 bucks on the bendix one vs 20 bucks for all the different aftermarket ones?

tom


RE: Air govenor - Land Yacht - 07-15-2018

I would NOT recommend one with the blue cap, see pictures. It failed after a year, and does not appear to be easily adjusted with a screw driver and wrench.

Thanks Steve for posting this in parts replacement. I will try to remember next time.