Cummins governor - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Drivetrain (https://newellgurus.com/forumdisplay.php?fid=4)
+--- Thread: Cummins governor (/showthread.php?tid=4594)

---

Cummins governor - Gregory - 11-05-2018

A couple of months ago I had my coach (#1630) at the factory for a few items to work on.  While there I asked my service advisor (and another customer) about getting the speed governor changed slightly.  It is set for 75 MPH and I understand why.  My problem is when overtaking a semi, other bus, or just slower traffic sometimes while going up a slight incline, I start losing speed and can't complete the pass.  I would like to get the governor changed slightly so I can get a little more out of it when performing tasks such as this.

Does anyone know of a Cummins service center near Houston, TX that can perform this task?

Thanks for any help!

Gregory

---

RE: Cummins governor - Trainer - 11-06-2018

Gregory,

Contact ECU King in Santa Fe, TX. They can do what you need to set the speed in the engine computer.

They are on Hwy 6 south of Alvin, southeast of down town Houston.

409.927.1800

---

RE: Cummins governor - Gregory - 11-07-2018

(11-06-2018, 06:48 AM)Trainer Wrote:  Gregory,

Contact ECU King in Santa Fe, TX.  They can do what you need to set the speed in the engine computer.

They are on Hwy 6 south of Alvin, southeast of down town Houston.

409.927.1800

Rudy,

Thanks for the help.  I will give them a shout!

Best,
Gregory

---

RE: Cummins governor - MrE - 11-08-2018

You might want to consider buying the Cummins Inline Data Link Adapter. You can get Chinese knock-offs for under $200. It will allow you to adjust all the ECM parameters. There is an excellent website for information - http://rawze.com/forums/index.php Go to the 'ISX Related Help' page. There are also some great documents at http://rawze.com/forums/forumdisplay.php?fid=38 that will answer a lot of questions for you.

---

RE: Cummins governor - Gregory - 11-26-2018

(11-08-2018, 03:27 PM)MrE Wrote:  You might want to consider buying the Cummins Inline Data Link Adapter. You can get Chinese knock-offs for under $200. It will allow you to adjust all the ECM parameters. There is an excellent website for information - http://rawze.com/forums/index.php Go to the 'ISX Related Help' page. There are also some great documents at http://rawze.com/forums/forumdisplay.php?fid=38 that will answer a lot of questions for you.

That sounds like a good approach.  I will look that stuff up and see what I can learn, maybe doing it myself is possible.

Thanks,

Gregory

---