You are not logged in or registered. Please login or register to use the full functionality of this board...


Power into coach on legs 1 and 2 on a 1997 #443
#1

I have my coach plugged in at home and just noticed that the the 2 gauges (line 1 and 2) above the drivers seat were not showing power.  The inverter shows 13.65 and my outside surge protector shows 122 and 120 on each line going in.  Also shows about 5 amps used on line 2.  I turned off the shore power and fired up the generator with the same results, the line 1 and 2 lights on the generator control panel above the driver seat not lit as it usually is.  Now for my question - would having the front, middle and rear air conditioner breakers turned off cause this?  My middle AC unit went out, so while new parts are ordered, the shop turned all 3 breakers off.  I ask this because on a recent trip, the middle AC breaker tripped, and I saw that line 2 power was out.  Reset the breaker and had line 2 power back on.  Any ideas short of turning the 3 breakers back on to see any changes?  Thanks.

Emerson A.
1997 Newell #443
2008 Jeep Wrangler
Reply


Messages In This Thread
Power into coach on legs 1 and 2 on a 1997 #443 - by EArnold3 - 06-24-2020, 12:40 PM
RE: Power into coach on legs 1 and 2 on a 1997 #443 - by House Divided - 06-24-2020, 02:06 PM
RE: Power into coach on legs 1 and 2 on a 1997 #443 - by EArnold3 - 06-24-2020, 02:09 PM
RE: Power into coach on legs 1 and 2 on a 1997 #443 - by House Divided - 06-24-2020, 02:16 PM
RE: Power into coach on legs 1 and 2 on a 1997 #443 - by EArnold3 - 06-24-2020, 02:24 PM
RE: Power into coach on legs 1 and 2 on a 1997 #443 - by bikestuff - 06-24-2020, 03:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)