You are not logged in or registered. Please login or register to use the full functionality of this board...


110V air compressor spitter valve
#11

i may stand corrected. here is the description of that valve

i will have to go out and actually see how mine is hooked up.

tom

RAP6354 Air Solenoid Valve -CHECK LEAD TIME-
Product ordered in new from the manufacturer, please call for in stock availability on rush orders as lead-time can be 2-5 days before it ships.

Air Solenoid Valve

12 Volt | Packard and Ring | Normally Open

Abbreviated Description: “VLV SOL A 12V/NO/PKD&RNG"

tom

2002 45'8" Newell Coach 608  Series 60 DDEC4/Allison World 6 Speed HD4000MH

Reply
#12

   

Mark & Beverly Fincke
99 Newell Show Coach, # 527 (Heavy Metal)
Twin Slides, Rear Bath
08 Saturn Vue XR  SUV Toad


99 Escalade ESV.
Reply
#13

The solenoid is normally open and closes when the compressor turns on and opens to release the pressure and drain the bowl when the compressor turns off.

Ron & Jennifer Ward
2003 Newell Show Coach #643 (Racer Bus) Triple Slide, DD 60
Visalia, CA

Reply
#14

For you electrical gurus, can this valve replace the HWH spitter valve that Newell used????

https://www.amazon.com/SNS-2WK025-N08-El...59LP&psc=1

Steve Bare
1999 Newell 2 slide #531
Reply
#15

Working pressure on that valve is 100 psi so it would be better to find one with a higher pressure rating. Other than that it should work.

Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486 

1993 Newell 39' #337 
Reply
#16

I know that it is slightly below my 110V compressor pressure, but might be an alternative to try. I don't find a normally open valve with 1/4" npt that is rated higher.

Steve Bare
1999 Newell 2 slide #531
Reply
#17

There is an alternative and more cost effective solution. Use a standard air compressor controller with pressure relief. Plumb the relief line to the bottom of the spitter eliminating the solenoid valve. The controller will take the place of the well pump switch.

https://www.amazon.com/Compressor-Pressu...PUKC&psc=1

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#18

Steve,

check out my 110v air compressor layout in the above reply.

You can see the pressure switch from Grainger's that will release the air so the compressor can easily start.

Mark

Mark & Beverly Fincke
99 Newell Show Coach, # 527 (Heavy Metal)
Twin Slides, Rear Bath
08 Saturn Vue XR  SUV Toad


99 Escalade ESV.
Reply
#19

I replaced my spitter valve with the one from Amazon below.  It took getting some reducer adapters as the old one is 1/8" npt.  The new one is 1/4" npt.  It worked great.  Will see if it lasts any better than the original ones.  In fourteen years I have replaced the valve 3 times.  $21 compared to $150.

https://www.amazon.com/SNS-2WK025-N08-El...59LP&psc=1

Steve Bare
1999 Newell 2 slide #531
Reply
#20

I used the same switch as Richard shows above. I noticed that after a few months it would begin to bleed off air before it tripped off. I remedied that by slightly bending the tab that contacts the needle of the unloader valve.

1993 Newell (316) 45' 8V92,towing an Imperial open trailer or RnR custom built enclosed trailer. FMCA#232958 '67 Airstream Overlander 27' '67GTO,'76TransAm,'52Chevy panel, 2000 Corvette "Lingenfelter"modified, '23 Grand Cherokee.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)