10-28-2014, 04:17 PM
Hi Gang,
I just drove 1200 miles from Tulsa to my winter home base in Las Vegas. Major problem when I stopped, the hwh leveling system 680 series won't work. It won't add or delete air. I talked with Mike Ellis at Newell and we tried all he knew to no avail. He told me to call HWH Corp. and ask for a tech, so I did. The girl on line there told me the techs were very busy, but she would have them to call me in about 2 weeks. That's when I told her that didn't seem to be a very good way to run a business and that's when she hung up. I have the an old operator's manual for the 680 series, plus I read some of the new manuel Steve Bare but in. No where can I find a trouble shooting list. I've checked all of the fuses I can find, all ok. I have air 80 and 70 psi. it was 110 and 100 before I pumped the brakes down. When I have it out of gear with the parking brake on and I push the air button the lights all flash on, the red ones go out, the 4 yellow stay on until I take my finger off the air switch, then only light is the travel light. As I was coming out of Flagstaff I ran over what looked like a piece of trim from a car and it something under the rig. I read somewhere that the level sensing unit may be between the front tires. I don't know what to look for here. One of my safety cables for my car was ground in two, It was a little bit to long and could have just dragged or I could have lost air in the back allowing it to drag. Anyway I need your advise and suggestions. My unit is #516, almost the same as Steve's.
Thanks for your help.[/u]
I just drove 1200 miles from Tulsa to my winter home base in Las Vegas. Major problem when I stopped, the hwh leveling system 680 series won't work. It won't add or delete air. I talked with Mike Ellis at Newell and we tried all he knew to no avail. He told me to call HWH Corp. and ask for a tech, so I did. The girl on line there told me the techs were very busy, but she would have them to call me in about 2 weeks. That's when I told her that didn't seem to be a very good way to run a business and that's when she hung up. I have the an old operator's manual for the 680 series, plus I read some of the new manuel Steve Bare but in. No where can I find a trouble shooting list. I've checked all of the fuses I can find, all ok. I have air 80 and 70 psi. it was 110 and 100 before I pumped the brakes down. When I have it out of gear with the parking brake on and I push the air button the lights all flash on, the red ones go out, the 4 yellow stay on until I take my finger off the air switch, then only light is the travel light. As I was coming out of Flagstaff I ran over what looked like a piece of trim from a car and it something under the rig. I read somewhere that the level sensing unit may be between the front tires. I don't know what to look for here. One of my safety cables for my car was ground in two, It was a little bit to long and could have just dragged or I could have lost air in the back allowing it to drag. Anyway I need your advise and suggestions. My unit is #516, almost the same as Steve's.
Thanks for your help.[/u]