05-08-2015, 06:39 AM
Gang,
My Girard main awning (Girard G-2000) was not adjusted for slope and essentially extended straight out from coach. This caused two problems. 1) It was ugly and looked weird. 2) Water would pool in the middle of the fabric during rain storms.
Steve Bare, loaned my his "Adjustment and Repair Manual". The book give you insight into how to make the adjustment but came up a little short.
This post is to provide a little insight and some pictures which should help you get started.
1) Extend your awning a few feet
2) On one arm loosen both side bolts on the out base of the arms. (See pictures)
3) Adjust the bottom adjustment bolt. (counter-clock-wise to lower)
4) Repeat for other arm.
5) Once you are pretty close, extend the awning and measure from the ground to the front of awning, and again from back. (You are going for 3 degrees of front to back tilt).
6) Pull the awning in and make fine adjustments until you have the right slope away from coach and the correct front to back slope.
7) Tighten the set bolts .
8) Enjoy a cold beverage under your newly adjusted awning.
Cheers,
bill
My Girard main awning (Girard G-2000) was not adjusted for slope and essentially extended straight out from coach. This caused two problems. 1) It was ugly and looked weird. 2) Water would pool in the middle of the fabric during rain storms.
Steve Bare, loaned my his "Adjustment and Repair Manual". The book give you insight into how to make the adjustment but came up a little short.
This post is to provide a little insight and some pictures which should help you get started.
- Each arm is adjustable, and from what I experienced has a wide adjustment latitude.
- There are two bolts that need too be loosened and one that does the adjustment.
- In order to make the adjustments easier, only extend your awning a few feet. (Fully extended puts a lot of weight on the adjustment bolt).
- You are going for 20 (or more) degrees down angle from the coach, and a 3 degree front to back angle.
- Use a 19mm (3/4") wrench on both the set bolts and the adjustment bolt.
- It takes a lot of torque to move the bolts (I tried some WD40 and it helped but did not make it easy)
- The overall adjustment is not difficult.
- **The manual said to turn clock-wise (looking from the bottom) to lower. In my case your had to go counter-clock-wise.
1) Extend your awning a few feet
2) On one arm loosen both side bolts on the out base of the arms. (See pictures)
3) Adjust the bottom adjustment bolt. (counter-clock-wise to lower)
4) Repeat for other arm.
5) Once you are pretty close, extend the awning and measure from the ground to the front of awning, and again from back. (You are going for 3 degrees of front to back tilt).
6) Pull the awning in and make fine adjustments until you have the right slope away from coach and the correct front to back slope.
7) Tighten the set bolts .
8) Enjoy a cold beverage under your newly adjusted awning.
Cheers,
bill