11-01-2012, 03:55 PM
Richard & Steve did such a great job explaining the rear axles air suspension plumbing, I felt compelled to understand my older setup.
I've done a chart of all the different setting & switch positions to understand what activates what.
I can't seem to be able to paste or attach a copy but I'm sure I will figure it out.
Two conditions surprised me.
1. To dump the tag axle, the ignition switch on & leveling switch must be in the up position. If the leveling switch is in the off position, the travel valves are activated & the whole system will empty through the exhaust valves.
2. The individual rear L/R U/D switches will raise the drive & tag side when activated. When in the down position, only the drive is lowered & the tag gets a lot of weight!
To my knowledge my wiring is original.
My original plan was to change my plumbing to the later style, but Richard suggested differently. He is correct.
My question now is is there any reason for (2)travel solonoids on the tag 6 pack. Air to the 6 pack is controlled by a solonoid operated by the same circuit that operates the tag travel solonoids. If those 2 travel solonoids were blocked to a normally open condition, no functionally would change! To go one step further, I believe a single exhaust solonoid could handle the tag assy, as currently both solonoids are tied together electrically.
Basically I see the tag supply pressure regulator, a 3 way dump valve & then split into to 2 3way raise valves supplied by air from before the regulator, & then on to the air bags. 3 solonoids in total <$50; and have 6 spare solonoids!
Sure appreciate any and all input.
I've done a chart of all the different setting & switch positions to understand what activates what.
I can't seem to be able to paste or attach a copy but I'm sure I will figure it out.
Two conditions surprised me.
1. To dump the tag axle, the ignition switch on & leveling switch must be in the up position. If the leveling switch is in the off position, the travel valves are activated & the whole system will empty through the exhaust valves.
2. The individual rear L/R U/D switches will raise the drive & tag side when activated. When in the down position, only the drive is lowered & the tag gets a lot of weight!
To my knowledge my wiring is original.
My original plan was to change my plumbing to the later style, but Richard suggested differently. He is correct.
My question now is is there any reason for (2)travel solonoids on the tag 6 pack. Air to the 6 pack is controlled by a solonoid operated by the same circuit that operates the tag travel solonoids. If those 2 travel solonoids were blocked to a normally open condition, no functionally would change! To go one step further, I believe a single exhaust solonoid could handle the tag assy, as currently both solonoids are tied together electrically.
Basically I see the tag supply pressure regulator, a 3 way dump valve & then split into to 2 3way raise valves supplied by air from before the regulator, & then on to the air bags. 3 solonoids in total <$50; and have 6 spare solonoids!
Sure appreciate any and all input.