03-11-2023, 11:47 AM
Hi Everyone,
So the crack I had in the metal portion (Blower Housing) Finally went all the way through. So I have a new one coming. I noticed that the plastic housing around the motor (the outer casing) also has a crack and the o-ring from the parts diagram is missing.
2 Questions..
1. Do I need to repair the outer plastic housing (will it cause mixture/combustion problems?) if yes, how? Glue, high temp tape??
2. The red 12V Motor wire on C2 what is that connected to at the other end from the connector?? Mine comes out of the wire loom and it must have broken off while I was removing the burner.
I am in a tough spot as I am leaving for the factory this upcoming Friday and will only receive the metal blower housing on Tuesday, so little time to reassemble, especially given the nasty snow and ice we are having!
So wish there was someplace more local for parts!
Help!
Thank you!
So the crack I had in the metal portion (Blower Housing) Finally went all the way through. So I have a new one coming. I noticed that the plastic housing around the motor (the outer casing) also has a crack and the o-ring from the parts diagram is missing.
2 Questions..
1. Do I need to repair the outer plastic housing (will it cause mixture/combustion problems?) if yes, how? Glue, high temp tape??
2. The red 12V Motor wire on C2 what is that connected to at the other end from the connector?? Mine comes out of the wire loom and it must have broken off while I was removing the burner.
I am in a tough spot as I am leaving for the factory this upcoming Friday and will only receive the metal blower housing on Tuesday, so little time to reassemble, especially given the nasty snow and ice we are having!
So wish there was someplace more local for parts!
Help!
Thank you!