Newell Gurus

Hi All,
Having some plumbing bay issues. does anyone have a source for the PMMI Tank monitors ? I have two located over the micro inside and one installed on the chrome fascia in the water bay. The company no longer makes them from what I understand and Newell hasn't come up with a resolve yet since they started having them fail. This is the 3x6 board and the red readout for pure and waste is about 1x3 with a display in little round red dots.

Did you make sure the ribbon cable is plugged in?
On mine the display in the basement didn't work until I plugged the cable back in.

It's in Forest and looking for a replacement monitor....Any source ? Newell says stopped making long time ago and has no fix/replacement.
Anyone have a part # , source, rebuilder ???

Here is some contact info but don't know any more.
http://www.pmmi-electronics.com

That's a Houston number me thinks.
I'll there later this week.

When mine failed I found a bad solder connection on the board

Taking out monitor later this week when I have dry ground to work on and will look it over and try to clean all the contacts and magnify the solder points. May be an easy fix. HaHa... Good news is I cleaned up my Mach 5 problem by cleaning all the calcium gunk out of everything and flushing over and over the entire system.

Larry

We went with seelevel gauges set up
www.rvgauge.com
Might take a look and see if that will work