 Last additions
|

Paint Project - back - new tail lights654 viewsfirst time for this stuffSep 04, 2018
|
|

Paint Project - after the silver/gray and white733 viewsfirst time for this stuffSep 04, 2018
|
|

Paint Project - starting to mask for the black around the windows - ended up with all one color748 viewsfirst time for this stuffSep 04, 2018
|
|

Paint Project - primer and the first silver/gray sprayed717 viewsfirst time for this stuffSep 04, 2018
|
|

Limit switches1178 viewsHere you can see the limit switches above the non-pass through bay. This is where the piece of angle iron is bolted on to trigger the limit switch at full extension. Unfortunately I did not get a picture with the angle iron installed.Aug 28, 2018
|
|

Slide ram disconnected1015 viewsHere you can see where the ram is disconnected from the coach and the slide has been pulled out, pulling the ram with it.Aug 28, 2018
|
|

Top of seal is installed1049 viewsAug 28, 2018
|
|

Floor is very close to wall1044 viewsHere you can see where the floor is very close to the wall and care must be taken when pushing the new seal into place to prevent damage.Aug 28, 2018
|
|

Installing bottom side of new seal974 viewsThe bottom edge is installed first. Note you can see the leather of the rear wall here, which doesn't extend past the aluminum rear side of the slide, so we did not have to remove it. Coach is filthy because we didn't wash it while the seal was blown. You can also see the white powder ejecta on the rear face of the slide where the old seal blew up.Aug 28, 2018
|
|

Pull slide out this far1098 viewsSlide is pulled out far enough for lock pin holes to clear side of coachAug 28, 2018
|
|

Slide seal placed around slide and then slide is supported externally1034 viewsAug 28, 2018
|
|

Front ram connection1071 viewsThe front ram connection is located behind an access panel in the front passenger wheel well. The access panel is riveted in place.Aug 28, 2018
|
|

Rear ram connection987 viewsThe rear ram connection is located in the large pass through bay on the passenger side, rear end of the bay. Bolt is 1 1/8".Aug 28, 2018
|
|

741 viewsAug 26, 2018
|
|

715 viewsAug 26, 2018
|
|

1156 viewsAug 23, 2018
|
|

SOLD THIS 1977 STRETCHED GMC TO ACQUIRE MY 1999 NEWELL1052 viewsAug 22, 2018
|
|

transfer switch1011 viewsschem.Aug 22, 2018
|
|

1492 viewsAug 17, 2018
|
|

786 viewsAug 17, 2018
|
|

776 viewsAug 17, 2018
|
|

813 viewsAug 17, 2018
|
|

791 viewsAug 17, 2018
|
|

749 viewsAug 17, 2018
|
|

767 viewsAug 17, 2018
|
|

784 viewsAug 17, 2018
|
|

904 viewsAug 17, 2018
|
|

829 viewsAug 17, 2018
|
|

849 viewsAug 17, 2018
|
|

852 viewsAug 17, 2018
|
|
| 2225 files on 75 page(s) |
 |
 |
 |
 |
 |
24 |  |
 |
 |
 |
|