Last additions - Newell Gurus Gallery

Home > User galleries

Last additions - User galleries

Paint Project - after the silver/gray and white63 viewsfirst time for this stuffSep 04, 2018

Paint Project - starting to mask for the black around the windows - ended up with all one color63 viewsfirst time for this stuffSep 04, 2018

Paint Project - primer and the first silver/gray sprayed67 viewsfirst time for this stuffSep 04, 2018

Limit switches121 viewsHere you can see the limit switches above the non-pass through bay. This is where the piece of angle iron is bolted on to trigger the limit switch at full extension. Unfortunately I did not get a picture with the angle iron installed.Aug 28, 2018

Slide ram disconnected113 viewsHere you can see where the ram is disconnected from the coach and the slide has been pulled out, pulling the ram with it.Aug 28, 2018

Top of seal is installed123 viewsAug 28, 2018

Floor is very close to wall112 viewsHere you can see where the floor is very close to the wall and care must be taken when pushing the new seal into place to prevent damage.Aug 28, 2018

Installing bottom side of new seal128 viewsThe bottom edge is installed first. Note you can see the leather of the rear wall here, which doesn't extend past the aluminum rear side of the slide, so we did not have to remove it. Coach is filthy because we didn't wash it while the seal was blown. You can also see the white powder ejecta on the rear face of the slide where the old seal blew up.Aug 28, 2018

Pull slide out this far129 viewsSlide is pulled out far enough for lock pin holes to clear side of coachAug 28, 2018

Slide seal placed around slide and then slide is supported externally105 viewsAug 28, 2018

Front ram connection125 viewsThe front ram connection is located behind an access panel in the front passenger wheel well. The access panel is riveted in place.Aug 28, 2018

Rear ram connection99 viewsThe rear ram connection is located in the large pass through bay on the passenger side, rear end of the bay. Bolt is 1 1/8".Aug 28, 2018