ZF accumulator - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Suspension/Tires/Wheels (https://newellgurus.com/forumdisplay.php?fid=5)
+--- Thread: ZF accumulator (/showthread.php?tid=8259)

---

RE: ZF accumulator - jdkskyking - 11-25-2024

(11-24-2024, 10:05 AM)johnkosir Wrote:  Have no light on dash with 0 psi in system, pressure switches seem to fail often has anybody thought about installing it on  a minemiss connector you don"t have to reduce pressure to 0 to change it, and you can check to see if it is working just by removing it.


I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

---

RE: ZF accumulator - hypoxia - 11-25-2024

(11-25-2024, 07:21 AM)jdkskyking Wrote:  

(11-24-2024, 10:05 AM)Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. Wrote:  JK 

I adjusted the Noshok 300L to about 170psi.  There is a switch function adjustment on the top of the 300L.  No particular reason for that pressure, I just got tired of pressurizing, depressurizing & adjusting it and 170 seemed reasonable.  I did not adjust hysteresis.  I have the DIN electrical plug.

(11-25-2024, 07:21 AM)jdkskyking Wrote:  [quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

[/quote]

(11-25-2024, 07:21 AM)jdkskyking Wrote:  [quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

[/quote]

(11-25-2024, 07:21 AM)jdkskyking Wrote:  [quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

[/quote]

---