You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Basement A/C unit not starting - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Air Conditioning (https://newellgurus.com/forumdisplay.php?fid=8)
+--- Thread: Basement A/C unit not starting (/showthread.php?tid=86)

Pages: 1 2 3 4


RE: Basement A/C unit not starting - Fulltiming - 07-26-2014

Good luck Dean, if you can find one, you are a better finder than I am. That's why I two of had mine rebuilt at a cost likely greater than the cost to replace them.


RE: Basement A/C unit not starting - Dmatz - 07-27-2014

Heck with a company Johnstones Supply http://www.johnstonesupply.com/storefront/index.ep they are a national supplier to the HVAC industry.


RE: Basement A/C unit not starting - Fulltiming - 07-27-2014

Thanks Doug, I will add that one to my bookmarks. At the time, we checked all of the supplier books that the electric motor repair/rebuilt shop had and could not find one that matched the specs (size, shaft diameter, rotational speed, hp, etc) of the one originally used on the old Dometic units.


RE: Basement A/C unit not starting - Fasteddie - 10-29-2014

I have a friend who has the same problem with that motor. Not able to find a replacement, so if you could give me the contact info on the company in NM that repaired it that would be great. We have not been able to find a rebuilder in the Dallas area.

Thanks Fasteddie
214 384-6339 cell


RE: Basement A/C unit not starting - Shamu406 - 05-17-2017

I have 3 condenser fan motors that are bad. Does anyone know where to get them? They are Emerson k33hxcdk-929
I'm going to a rebuilder today, hoping they can be done. But need a Plan B, if needed.
Someone mentioned Johnstone Supply, but they do not show any in a search on their site.
Thanks all.


RE: Basement A/C unit not starting - ccjohnson - 05-17-2017

We had one of ours replaced in Phx. They could not find exact motor so them got an air cooled one from Grainger but had to cut shaft as I recall. Can't find the exact number for it. Newell had same info for us. Ours is the Duotherm split system so it may not apply if you have the newer basement air system.


RE: Basement A/C unit not starting - Shamu406 - 05-17-2017

I believe mine is the Dometic system. This is a 1996 Newel. the guy here at the rebuild shop says he cannot get them anymore nor or rebuild them. But for $275 a piece he can find a replacement but it needs the squirrel cage drilled out for the shaft if it and to remove the brackets. All in all a 1170.00 for 3 to be handed back to me to install back in the coach. Ouch! Anyone have any other suggestions for me?

Correction, 1070.00


RE: Basement A/C unit not starting - folivier - 05-17-2017

Look for a shop that rebuilds electric motors, if they can't rebuild yours they might be able to adapt a new one to fit. I din't think there's anything special about that motor except the shaft size and length.


RE: Basement A/C unit not starting - HoosierDaddy - 05-17-2017

The rebuilder probably cannot get the bearings. I'm thinking there is a thread here someplace where someone bought a new similar motor and swapped the end plates .


RE: Basement A/C unit not starting - Shamu406 - 05-17-2017

I ordered 3 condenser motors from Grainger #3RCX7
Dwight at Newell said they installed these for a customer recently.
They come with a capacitor too, 85.00 each
Hope they do the job.