Front Stabilizer bar bracket broken - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Suspension/Tires/Wheels (https://newellgurus.com/forumdisplay.php?fid=5)
+--- Thread: Front Stabilizer bar bracket broken (/showthread.php?tid=2999)

---

Front Stabilizer bar bracket broken - InfiLights - 07-25-2016

Hi all,

Looking for info on the correct part to buy and replace.

As I drove the coach yesterday to get some water and sanitize the  system, I heard again the clunk I experienced when I brought the coach home.
It happens on 90 deg , tight turns, a bang when the wheels are coming back to straight....

Crawled under (to see better the Howard Power center cylinder as well) and I find out that the driver side U shape bracket that is supposed to hold the rubber busing on the stabilizer bar in place, is broken, allowing the bar end to somewhat float. It is kept there by the broken, popped up bracket and the outside bolt.  

I need to buy a new bracket. Anybody have a diagram and a part number so that I can get it coming ? What I am looking for ?
Appreciate it.

---

RE: Front Stabilizer bar bracket broken - qcj - 07-25-2016

(07-25-2016, 06:43 AM)InfiLights Wrote:  Hi all,

Looking for info on the correct part to buy and replace.

As I drove the coach yesterday to get some water and sanitize the  system, I heard again the clunk I experienced when I brought the coach home.
It happens on 90 deg , tight turns, a bang when the wheels are coming back to straight....

Crawled under (to see better the Howard Power center cylinder as well) and I find out that the driver side U shape bracket that is supposed to hold the rubber busing on the stabilizer bar in place,  is broken, allowing the bar end to somewhat float. It is kept there by the broken, popped up  bracket and the outside bolt.  

I need to buy a new bracket. Anybody have a diagram and a part number so that I can get it coming ? What I am looking for ?
Appreciate it.

I would start by calling Newell.

---

RE: Front Stabilizer bar bracket broken - Richard - 07-26-2016

Measure the diameter of the sway bar. Then take a look at energysuspension.com. I got that by googling 1.25 sway bar mount, but I'm not sure what diameter the sway bar actually is.

Fabricating one would not be hard.

---