Air valve to actuate the dump leaking -
Land Yacht - 06-07-2017
on my passenger side dump, there is a air valve that actuates the dump valve when you move the electrical toggle switch which is leaking. Tomorrow I will go buy the fittings to cap it off, then maybe I can remove it to see what it is, but was hoping somebody might already know from the picture below.
The air line comes into the unit in the middle of 2 brass fittings that look like air bleed off valves. The lower one is leaking. Anyone familiar with this unit?
RE: Air valve to actuate the dump leaking -
encantotom - 06-07-2017
i have did these several times. if you do a search i describe my efforts with it.
they use these for the dump valves on both sides and my bay fridge/freezer slide.
what fails on them is the inner rubber plunger. i have taken many of them apart and all of them failed in the same way.
a new valve is 100-150 bucks. i think you can find the rebuild kits for 30 or so if i remember right.
tom
RE: Air valve to actuate the dump leaking -
encantotom - 06-07-2017
http://newellgurus.com/showthread.php?tid=3110&highlight=dump+valve
i have part numbers in the thread
tom
RE: Air valve to actuate the dump leaking -
Land Yacht - 06-07-2017
(06-07-2017, 07:14 PM)encantotom Wrote: http://newellgurus.com/showthread.php?tid=3110&highlight=dump+valve
i have part numbers in the thread
tom
Thanks Tom, I found the rebuild kit on eBay, it went up $5 since your post :-)
So the o-rings in the kit will fix the brass exhaust valve from leaking? The picture of the kit did not have the brass exhaust valves.
http://www.ebay.com/itm/ARO-118597-12-RK-FREE-Expedited-Shipping-NEW-Now-Includes-Parker-O-Lube-Tube-/222522905087?hash=item33cf6611ff:g:~d0AAOSw8lpZJaVM
RE: Air valve to actuate the dump leaking -
RussWhite - 06-08-2017
Hi Mike - I need to try the rebuild Tom suggests. I guess between the two of them ( one on each side of my coach ) they have been a PITA. My present solution, which is easy and inexpensive, was to install a needle valve in the incoming air line to the solenoid pair. When I need to change the position of the dump valve I open the needle valve, hit the switch and then close the valve. No more leaks!
Russ
RE: Air valve to actuate the dump leaking -
Chester Stone - 06-08-2017
I had to rebuild mine also. I understand the function of the device is to cushion the the paddle when opening or closing the sewer valve.
RE: Air valve to actuate the dump leaking -
encantotom - 06-08-2017
once in a hwile i find them on ebay for 20-30 bucks
you take them apart from the ends using a snap ring pliers
tom
RE: Air valve to actuate the dump leaking -
Richard - 06-08-2017
The brass exhaust valves were added by Newell. Adjusting them controls the opening and closing speed.
RE: Air valve to actuate the dump leaking -
folivier - 06-08-2017
I did like Russ but also added a switch at that compartment so I could operate the dump without going inside or having the ignition switch on.