You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Brass Plumbing Union Restoration - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Plumbing and fixtures (https://newellgurus.com/forumdisplay.php?fid=9)
+--- Thread: Brass Plumbing Union Restoration (/showthread.php?tid=6168)



Brass Plumbing Union Restoration - Winegrower - 07-07-2021

The Headhunter Mach5 outlet fitting cracked which required breaking open the 3/4 brass union above it.  After replacing the cracked female to male part on the Headhunter the brass union would not seat and leaked.  There being no replacement near our location I went to NAPA and picked up some valve grinding compound. I used a small vice to hold the lower half and a cordless drill motor with duck tape over the chuck to grab the upper half.  With a small amount of lapping compound between the parts I was soon able to get the two parts well mated.  On reassembly no leaks with less torque on the mating ring as well.