Slide seal replacement - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Slides (https://newellgurus.com/forumdisplay.php?fid=55)
+--- Thread: Slide seal replacement (/showthread.php?tid=6722)

---

Slide seal replacement - kmeinke - 04-10-2022

I have a 2015 (coach 1517) and everything is fine at this point.  When inspecting the slide seals, a couple of them are showing signs of wear.

What is the "normal" time that these need to be replaced, and what is the cost to have this service done

Thanks

---

RE: Slide seal replacement - CaptainGizmo - 04-10-2022

Funny...this was just asked on the Facebook group!

To remove the Salon Driver slide is a major task; 10 hours, and that’s just to take the room at to access the seal.

Are you talking about the SEAL, or the SEAL WIPE? Obviously, the seal will be a lot more work.

One gent said he was quoted about $20k for all four slides. That sounds about right, considered the salon alone is around $2000 just to move out.

---

RE: Slide seal replacement - rheavn - 04-10-2022

I don't believe there is a normal. Everyone I know replaces them when they fail. My coach had the original slide seals when I purchased it in 2010. In 2021 the bedroom seal developed a leak--seal was 22 years old. Had it replaced at Newell. Just under $2000 for the seal & labor. Took about 4-5 hours.

The salon seal has not been replaced and is now 23 years old.

---

RE: Slide seal replacement - kaptain - 06-23-2022

I came to this thread because I am searching for information about seal replacement.
My coach 701 just got air suspension replaced at a truck repair shop, but it is still an air leak on the front-right slide (maybe rear-right? I forgot).
The tech in the shop says they don't work on slides or seal replacement. I wonder how difficult the job is, and whether possible to do oneself.

---

RE: Slide seal replacement - johnkosir - 06-23-2022

Not difficult for Valid slides , need over extenders i posted dimensions and picture on the site ,no cart required. I changed the driverside bedroom seal at a Guru rally with the help of Roger 1 and Keith Tomaso the hardest part was finding the screws to take the room apart

---

RE: Slide seal replacement - hypoxia - 07-23-2022

Is there any difference between the early 2000's Valid slides and seals and the newer 2014's Valid slides and seals? I have the 2008 Valid Service Manual VSS90M-001-SM, is there a newer version available? Also where is the air line connection to the seal located and is it a normal quick connect fitting? I was told it may be on the top at the center of the seal. My driver side bedroom has a leak I need to trace which may be the line, connector or the seal.

---