You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Cleaning out the parts bin - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Parts is parts (https://newellgurus.com/forumdisplay.php?fid=28)
+--- Forum: Parts Swap/Giveaway/Sell (https://newellgurus.com/forumdisplay.php?fid=71)
+--- Thread: Cleaning out the parts bin (/showthread.php?tid=8365)



Cleaning out the parts bin - Richard - 02-17-2025

I have a number of things left over from the sale of the 99. Email [email protected] if interested. Buyer pays postage. 

Seals for HWH lock pins or cylinders, enough to do 4. $10.00
One rebuilt and tested (new seals) slide cylinder for front slideout.   $500  They are over a 1000 from HWH and six or more week lead time. 
Two fuel filters for generator, WIX 3417  $25 for both
Three Firestone air bags for drive axle. Used. The have the large inlets. No signs of cracking and less than ten years old. Yours for the shipping. 
One front airbag for the Dana IFS 84 suspension. Large inlet, age unknown, but no cracking. Yours for the shipping. 
Two Koni Red shocks for the rear. Very good shape, took them off to use Roadkings, RK's were no better. 50 for the pair.
One rebuilt Aquahot circulation pump. Tested, works, leak free, ugly. $25
One almost new drive motor for generator blower. $50



I also have a DDEC III engine control module that was original to the 12.7 Series 60 Engine. It has a small problem with the memory module in that it does not keep track of mileage in one of the memory registers that feed a VMSPC. It runs the engine just fine, with no check engine or stop engine codes. I replaced it with a DDEC IV which corrected the fuel mileage calculation on VMSPc. It would be a great spare to carry on board for a 12.7 Series 60. A remanufactured DDEC III can run over 2000 greenbacks. I think 500 is a good price for the DDEC III


RE: Cleaning out the parts bin - rvguy - 02-20-2025

richard
which aqua hot circulation pump do you have ?
if its the old rae pump i will take it


RE: Cleaning out the parts bin - Richard - 02-21-2025

Adam, it is the same pump. Email me a shipping address. [email protected]


RE: Cleaning out the parts bin - rvguy - 02-22-2025

(02-21-2025, 05:20 AM)Richard Wrote:  Adam, it is the same pump. Email me a shipping address. [email protected]

check your email sent you the addresse


RE: Cleaning out the parts bin - Jonestead - 03-06-2025

Interested in most of the parts bin
Not sure if I'll see you this summer
Call me when convenient


RE: Cleaning out the parts bin - Richard - 03-07-2025

The parts bin is all gone! thanks to everyone who helped clean out the shop.