Wind shield wiper (driver side) inop - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Exterior (https://newellgurus.com/forumdisplay.php?fid=7)
+--- Thread: Wind shield wiper (driver side) inop (/showthread.php?tid=900)

---

Wind shield wiper (driver side) inop - pjhorton - 07-13-2013

Driving along and it starts to rain (natch!). The wipers start up fine and are running. Suddenly, the driver side wiper stops (natch!) in the full left position. The right side wiper continues to operate. Since the right side still works, the motor must be OK and the problem will be the linkage. How do you get to it? Remove the dash & what is next?

Phil Horton
Newell # 470

---

RE: Wind shield wiper (driver side) inop - Richard - 07-13-2013

Mine has separate motors, no linkage. Put some oil in the idler bushing on the front and see if that helps. Some of us have replaced the bushing because they wear out and seize

---

RE: Wind shield wiper (driver side) inop - folivier - 07-13-2013

Dittos on what Richard said. I pulled the wipers, cleaned the rust off the bushings, lubed, and worked great on my '93

---

RE: Wind shield wiper (driver side) inop - ccjohnson - 07-14-2013

Our passenger side was not working. We ended up replacing motor at Newell but it was a used one someone remembered being in a scrap bin. They had a few driver side motors left. Someone posted a link on another forum but I can't remember it for sure. But it had several motors for bus & rv wiper systems. motors have different rotational directions & internal switching as I recall.

---

RE: Wind shield wiper (driver side) inop - pjhorton - 07-17-2013

Checked the nuts under the clips and they were backed off about one half a turn. Lubed mechanism and tightened. Wiper works. Thanks for all the help.

Phil
'98 # 470

---