You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Rear curb slide seal leak - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Emergency Coach Help Needed (https://newellgurus.com/forumdisplay.php?fid=77)
+--- Forum: Help, I need help ASAP (https://newellgurus.com/forumdisplay.php?fid=78)
+--- Thread: Rear curb slide seal leak (/showthread.php?tid=9156)



Rear curb slide seal leak - Robcubelo - 11-17-2026

Have a leak in my rear slide right where it splices.  I turned off the regulator to stop it from continuing to air up.  Have the pressure to 1.4 psi, as low as it will go.  I can't get it fixed until April at Newell and looking for someone in the South to help.  Any recommendations?  Thank you for the help!  
Rob
2004 685


RE: Rear curb slide seal leak - johnkosir - 11-18-2026

The rear driver side seal in 712 was pinched over to shorten it it was not spliced that might be repairable with out changing seal I changed my seal at a Newell gathering at a camp ground









t


RE: Rear curb slide seal leak - Richard - 11-18-2026

Kris Jones, Precision Coach, Zephyr Hills, Fl.
Motor coach Store, Bradenton FL


RE: Rear curb slide seal leak - Jack Houpe - 11-18-2026

If you have vacuum pump installed on the seal turn the key on and let it suck the seal flat then put super glue on the leak and spray the area with accelerator immediately. It will stop the leak till you get it replaced. If you don't have vacuum plumps installed I highly recommend it. 

https://www.amazon.com/Glue-Activator-Cyanoacrylate-Super-Accelerator/dp/B0D4R1HLDF/ref=sr_1_4?crid=1L13TDE1KWR2G&dib=eyJ2IjoiMSJ9.8JF4MlyHeWvaCg17Uf_bncz7S3Hl-9ycX9Kz_VdTDc4SATA0mr_Ndshr1XiZ5o_Hcm0sGYYPTp8kX66aEzERd8REArUrmI8Ox7_3oHVvF-n_ezVGvEvFqb9BnFRZYXgqR5vayNPYj2E6aW9LK_YM30hJimrt28rmqnyPdIZX-i63GQ83qawKzUT_U2WikNpIQ7Agndoo3egUNO50hGXDT-7Mh4DMfxfZ38IsZ5hnwsc.eZNtmLnTiMzycYUZtj4QB7NJJPpRMV9kIwaGjgqRcig&dib_tag=se&keywords=super%2Bglue%2Band%2Baccelerator&qid=1795004514&sprefix=super%2Bglue%2Band%2B%2Caps%2C301&sr=8-4&th=1


RE: Rear curb slide seal leak - Robcubelo - 11-18-2026

(8 hours ago)johnkosir Wrote:  The rear driver side seal in 712 was pinched over to shorten it it was not spliced that might be repairable with out changing seal I changed my seal at a Newell gathering at a camp ground









Thank you, I'll look into that.