You are not logged in or registered. Please login or register to use the full functionality of this board...


Brass Plumbing Union Restoration
#1

The Headhunter Mach5 outlet fitting cracked which required breaking open the 3/4 brass union above it.  After replacing the cracked female to male part on the Headhunter the brass union would not seat and leaked.  There being no replacement near our location I went to NAPA and picked up some valve grinding compound. I used a small vice to hold the lower half and a cordless drill motor with duck tape over the chuck to grab the upper half.  With a small amount of lapping compound between the parts I was soon able to get the two parts well mated.  On reassembly no leaks with less torque on the mating ring as well.

Sandy and Bob McBratney
Previous owners of 2007 Newell #1202  "Boomer" 
Reply


Messages In This Thread
Brass Plumbing Union Restoration - by Winegrower - 07-07-2021, 08:15 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)