You are not logged in or registered. Please login or register to use the full functionality of this board...


Gas spring tool
#21

Sounds great. I'll want to see it. On my pipe clamps I would have to grind one end thinner to fit on the gas spring on the inside of the mount. Is yours going to have to be thinned down on the one end?

Steve Bare
1999 Newell 2 slide #531
Reply
#22

Can’t believe I didn’t post this - for the engine bay doors 
Notice the intentions for the spring head to fit in - I think I used a half inch drill bit and the upper/outer holes did the job


Attached Files Thumbnail(s)
   

Karen & Adrian Abshire 
1998 2 slide 45' Newell Coach 498 
Prior: 1985 Foretravel ORED 35, 1988 38' Foretravel U280, 2000 Foretravel 42' U320, 1990 Bluebird Wanderlodge WB40
Reply
#23

i just recently changed them on my 99. i just used a ratchet strap and it was super easy

tom

2002 45'8" Newell Coach 608  Series 60 DDEC4/Allison World 6 Speed HD4000MH

Reply
#24

This is BRILLIANT!!

How can I get one?

Be seeing you,

Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan


Reply
#25

The one I made is just a Harbor Freight clamp (cheap) and drill about 1/8” holes to accept the spring. The one Steve Bare made you would need to ask him about but I’m thinking I may try my *new* welding skills out and make some! Steve’s is probably easier to use than mine…

Karen & Adrian Abshire 
1998 2 slide 45' Newell Coach 498 
Prior: 1985 Foretravel ORED 35, 1988 38' Foretravel U280, 2000 Foretravel 42' U320, 1990 Bluebird Wanderlodge WB40
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)