You are not logged in or registered. Please login or register to use the full functionality of this board...


Dinette Table Size and Construction?
#1

Since I do not have a dinette table, I am going to have one fabricated from the original material.

i see two basic shapes from Newell's of my era. Round end and flat end with rounded corners. Either way, can someone measure it and tell me it's width )seat to seat) and length (from the wall. Also..if possible height of top above the floor.

Also, if anyone knows what epoxy is used both to assemble the layers and to fill in the routed trim line groove, I would be grateful!

Thanks,

Be seeing you,

Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan


Reply
#2

My table is an oval
    28 3/8" wide
    38 1/4" long
    28 3/4" high
    3" from wall
Dinette seat back to seat back is 70 1/2"


Attached Files Thumbnail(s)
   

Steve Bare
1999 Newell 2 slide #531
Reply
#3

Thanks Steve

Be seeing you,

Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)