You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Plumbing Fixtures - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Plumbing and fixtures (https://newellgurus.com/forumdisplay.php?fid=9)
+--- Thread: Plumbing Fixtures (/showthread.php?tid=1744)



Plumbing Fixtures - PlazaGuy - 08-13-2014

Need help with a plumbing problem. We have a "new" coach 2002 Newell, rear bath. Integrated Grohmix shower fixture. We have no hot water coming through the shower head, however, there is hot water to the fixture. Have disassembled, followed all instructions, can't find ANYTHING wrong. Does this mean the thermo element is bad. HELP.


RE: Plumbing Fixtures - folivier - 08-13-2014

The Grohe fixtures have a lifetime warranty. Contact them and they will send you a new cartridge, or whatever else you need. BUT it may take a few weeks to get it in. Kinda difficult to wait that long for a hot shower but at least you will have a spare.
Do all of your other faucets have plenty hot water? If so that will eliminate any problems with the Aquahot.


RE: Plumbing Fixtures - PlazaGuy - 08-13-2014

Fortunately, we aren't going anywhere right away. Still trying to figure out how everything works. Lots of difference between our old 1990 and the 2002! We have a grand-son-in-law that works for a plumbing supply company in K.C., so think maybe we can get one quicker....maybe.
Thanks for your speedy reply.Smile


RE: Plumbing Fixtures - bikestuff - 08-13-2014

I ordered one on Amazon and had it the next day....but it may not be the problem. The mixing valve associated with the aqua-hot could fail and be giving you "warm" water that is not hot enough to mix with the cold water. If you can figure out how hot it might give you a clue.

Do you *ever* get hot water out of the shower? If it runs hot for a minute or two then turns cold, I would look towards the aqua-hot.

You can search on this site for mixing valve and will get a lot of information. The bottom line is what most folks do is to buy a new valve and just change out the guts without disturbing the pipes.

Hope this doesn't send you down another rabbit hole!

Cheers,
bill


RE: Plumbing Fixtures - PlazaGuy - 08-13-2014

Thanks Bill...we do have hot water everywhere, including to the fixture, so I think the Aqua-Hot is working great.


RE: Plumbing Fixtures - roadappels - 08-13-2014

We had a similar problem on our 90 this past summer and Michael Day and I trouble shot a couple of hours and it turned out to be the anti-scalding valve...it was a delta faucet though. Rudy sprayed some anti-corrosion spray on the valve and we proceeded to move it enough till it was operational...not sure but do you have a hot, cold and then the third valve? If so, I bet that valve is corroded.

B


RE: Plumbing Fixtures - PlazaGuy - 08-14-2014

I remember that. We were at the rally in our 1990 Coach (the 2002 was at Newell getting the slides worked on). We were parked on the lake front between Chester and Gary. This is a little different beast, so I'm on my way this morning to Kansas City to see my granddaughter's husband at the plumbing supply house.


RE: Plumbing Fixtures - lbrachfe - 08-14-2014

Take the shower mixer apart and soak everything in Lime Away. I did this and increased my hot water flow from a 4 out of 10 to a 10 out of 10,,,and have done the same thing to the kitchen faucet mixer as well.


RE: Plumbing Fixtures - folivier - 08-14-2014

Larry, did you break the mixer valve apart? Or just soak the entire thing?
I've got my shower valve soaking in vinegar now.


RE: Plumbing Fixtures - lbrachfe - 08-14-2014

I soaked the whole thing and found I didn't need to go further than twisting back and forth submereged in a bucket of Lime Away. Grohe will send a new one FREE as you know so if you break it a new one is easily obtained. I have ordered a lot of parts from them and it usually takes less than a week to get them.