You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
AQUAHOT DIESEL SWITCH - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Heating Systems (https://newellgurus.com/forumdisplay.php?fid=11)
+--- Thread: AQUAHOT DIESEL SWITCH (/showthread.php?tid=2769)



AQUAHOT DIESEL SWITCH - hildjo - 03-02-2016

Hi, I am a new owner of a 1998 Newell. I am not familiar with Aquahot systems. When I put the aquahot in the diesel position, I hear it start the red light comes on, but after 15 minutes or so the light goes out. If I don't do anything else the temp will gradually go down and last night i noticed it had decreased to 138. I turned on the electric switch and it works just fine and stays within the parameters it is supposed to. Thanks for your help


RE: AQUAHOT DIESEL SWITCH - bikestuff - 03-02-2016

Hildjo,

First, you might want to add a name to your signature block. A lot of us also add our coach vintage. (It helps to understand the vintage of your coach for advice).

About the Aquahot, Rudy -- @"Trainer" is our resident expert.

To me it sounds as if you have a sensor or a burner problem. Can you say for sure when annual maintenance was last performed? If not, I would start with that. It involves taking the burner off, and replacing the diesel spray nozzle, and replacing the diesel filter along with some inspection and soot cleaning. Inside the burner is a sensor that detects if the burner is getting lit. It will shut everything down if it cannot light the fuel.

If the burner starts every time when you turn it on... (Not just the whiring noise, but actual firing up -- check exhaust) but then dies, it seems as if the temperature sensor is not telling the unit it needs to start. If this is the case, I would contact Rudy, and see what he recommends.

Cheers,
bill


RE: AQUAHOT DIESEL SWITCH - Trainer - 03-02-2016

hidjo,

The light going out inside indicates a firing issue with the diesel burner. If it has not been serviced lately or has been sitting waiting to sell for a while, Annual Service usually fixes it up fine.

Having said that, there are several components that could fail which would affect the firing sequence. Some in-expensive and some expensive. But servicing the burner diagnoses those issues.

Where are you located?