1984 coach remove driver control panel

1984 coach remove driver control panel - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Electrical (https://newellgurus.com/forumdisplay.php?fid=30)
+--- Thread: 1984 coach remove driver control panel (/showthread.php?tid=3336)

Pages: 1 2

1984 coach remove driver control panel - Guy - 02-12-2017

Remove driver , (dash) control panel?

Looking for someone who has had the dash control panel out on an 84 era coach

I am replacing the old 50 amp manual transfer switch with a new auto transfer switch. The original one was working fine, but had been repaired many times over the years, leaving a nest of wires inside it that made me uncomfortable.

I now have no use for the selector switch in the dash for shore/ generator, or the associated shore power indicating light. I removed the 10 screws on the drivers control panel, thinking there would be long enough leads on the back of it to gain access . I am not able to lift the panel up more than an inch or two, and don't want to break or unplug something. Am I missing something here? I am assuming that the factory put it together and then screwed it in, meaning there should be at last a foot of extra length in the wires?

The solution for yesterday was to put it back together and save it for another day Huh

RE: 1984 coash remove driver control panel - Guy - 02-15-2017

Am I the only one crazy enough to open up the dash " can of worms"?

I will try again Saturday.

RE: 1984 coash remove driver control panel - Richard - 02-16-2017

Many of us have been in there. I can't help cause my dash is way different than yours.

Do you have any access from the top? Access hatches?

Can you post a few pics of the dash and the top of the dash?

RE: 1984 coash remove driver control panel - folivier - 02-16-2017

Are you talking about the dashboard? Or the overhead cabinet? On my '93 there was a compartment door for the stereo, vcr, etc. in the overhead. There was a panel to the left that would unscrew to allow access to the back of that area. Look around, it's common for Newell to have access some way.

RE: 1984 coash remove driver control panel - Guy - 02-16-2017

The 84 dashboard is what I am working on. It it curved, and I am having interference trying to gain access. I can only lift it out about 2 inches. I don't know if there are devices catching on the way out , or if I have a cable or wire lead causing the issue. I am going to try to take a look with mirrors this weekend. While I have it open, I wold like to check the generator hour meter to see if it is getting power , as it does not function.

RE: 1984 coash remove driver control panel - 77newell - 02-16-2017

The 77 coach I had with the flat dash required workin from below, contortion skills and blood letting required.

I'm guessing the factory built the dash with wires attached, put it in place and then attached the far ends of wires, not always leaving enough slack to move the panel much. This and some plumbing arrangements were the source of unconscionable profanity on my part.

RE: 1984 coash remove driver control panel - Guy - 02-16-2017

Thanks Jon. Time for the chainsaw......

RE: 1984 coach remove driver control panel - Richard - 02-16-2017

On coach 390 that I owned, the best way to access the wiring under the dashwas to remove the center console. Then lying on my back I could get to most of the wiring that fed the gauges. Otherwise it was the bloodletting exercise Jon described. After a couple of times I could get the console out in ten minutes. The first time took longer to find the hidden screws.

RE: 1984 coach remove driver control panel - folivier - 02-16-2017

Hey Guy, a sawzall works better....

RE: 1984 coach remove driver control panel - kyleb - 02-16-2017

Might be a good time to consider lengthening the wires. . . . .