What is this? In the AH bay -
pairodice - 01-23-2019
There is air coming out of this when I turn on my 110v compressor (probably my 12-volt too but didn’t test it). It looks like the air is coming out of the nut/outlet nearest the outside of the coach (left side?).
RE: What is this? In the AH bay -
rheavn - 01-23-2019
Air solenoid for the dump valve.
https://www.zoro.com/aro-solenoid-air-control-14-no-coil-a212sd-000-n/i/G3491336/?gclid=CNDc9IzE3r8CFZRj7AodUwgA3w
RE: What is this? In the AH bay -
encantotom - 01-23-2019
i just talked to adrian. and told him where my air fittings were in the shop to disconnect and plug it with.
tom
RE: What is this? In the AH bay -
pairodice - 01-23-2019
Thanks Steve and Tom!
You think the valve is bad and leaking? I checked the connections and they seem tight? It sounds like the air is coming out of the tubing/compression fitting but it’s hard to tell.
RE: What is this? In the AH bay -
Land Yacht - 01-23-2019
There is a rebuild kit, or you can purchase the whole assembly. I will try to find my documentation
RE: What is this? In the AH bay -
pairodice - 01-23-2019
Thanks Mike, I think I’m just going to do like Tom suggested and disconnect it. Although I do have a macerator at home and that might be a good spot to put it in.
RE: What is this? In the AH bay -
Richard - 01-24-2019
Adrian, the most common failure is that the spool that shuttles back and forth in the valve starts to leak by. This is the type of shuttle valve that keeps pressure at all times on the cylinder. So when in closed position air pressure is applied to the dump valve to keep it closed, and the opposite is true.
I am commenting for posterity, so that when one is chasing air leaks in this setup, be aware that the spool in the valve body is the most common leak, BUT the orings in the cylinder can also leak.
RE: What is this? In the AH bay -
Chester Stone - 01-24-2019
You asked what this device is for. As I understand it the device softens the action of the air cylinders they open and close the sewer valves. The one in the AH bay assists the sewer valve to the curb side outlet. It is a knuckle buster to replace the one in the street side water bay. I had to replace mine.
RE: What is this? In the AH bay -
pairodice - 01-24-2019
Thanks guys, I’m going to dive into it this afternoon along with figuring out what’s going on with the AH system ...
RE: What is this? In the AH bay -
encantotom - 01-24-2019
i took my curbside dump one out and capped it off. i will never use that dump.
tom