generator water cooled exhaust manifold - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Generators (https://newellgurus.com/forumdisplay.php?fid=25)
+--- Thread: generator water cooled exhaust manifold (/showthread.php?tid=5135)

---

generator water cooled exhaust manifold - Fishinator - 08-26-2019

Gentlemen,
I have an 86 Perkins powering my generator and have a couple of questions. 

Does anyone have a Perkins connection for parts. I am needing a water cooled exhaust manifold. I have found a couple used ones on E-Bay and one on a Shipwreck Salvage website. There is also a Bowman heat exchanger out there they say is an upgrade. 

Also I am pondering the usefulness of the water cool exhaust manifold. Wouldn't the purpose of the exhaust heating the coolant be the same principal as a block heater? I get the water cooled exhaust manifold in a marine application where you are heating the cooler/cold fresh or salt water to keep the engine coolant temp at an efficient operating temperature, but I would think under normal operating conditions from April thru October keeping the temp between 150 and 190 wouldn't be a problem.  
I haven't had the coach out during the winter months nor do I plan on doing so. So couldn't I eliminate the water cooled exhaust manifold and use a regular exhaust manifold and wrap it, which would help cut down on extra heat in the generator compartment. Am I missing something........
 
Thanks in advance for your assistance. 

James

---

RE: generator water cooled exhaust manifold - Tf175 - 08-26-2019

Try PC Industries , 
Powerlinecomponents.com. for Perkins parts .

---

RE: generator water cooled exhaust manifold - Fishinator - 08-26-2019

Will do. Thanks

---

RE: generator water cooled exhaust manifold - HoosierDaddy - 08-26-2019

The Perkins in my ‘78 Newell didn’t have a water cooled exhaust manifold. Never had a problem with that.

---

RE: generator water cooled exhaust manifold - bestgenman - 08-27-2019

“ Wouldn't the purpose of the exhaust heating the coolant be the same principal as a block heater? “
I’m not an expert at all configurations people can come up with but, in my experience, water cooled manifolds serve to diminish heat gain in the engine compartment.  I have never seen one used for block heating.  I would think the purpose was to keep the exhaust heat down but if you decide to bypass then a blanket of high temp material could do the same job. Just keep in mind the exhaust gas temperatures can reach 900 degrees or more depending on load.   If there is enough air flow in your compartment, you can bypass insulation.

---