You are not logged in or registered. Please login or register to use the full functionality of this board...


Volt Ohm Meter Tricks and Hacks
#1

First, it’s Bill’s fault for starting this thread. I thought it was a great suggestion. I have seen other hacks gurus have done, so I expect this to be a thread with great content. 

Here are a few of mine. 

I wanted to diagram the big 12V positive cables that run all over the coach. But I didn’t have a fancy fox and hound cable signal tracer. I unhooked all the big cables where I could find them. I made a long wire with alligator clips at each end. I would clip the wire to one of the cables I wanted to trace and start with the Ohm meter at other cable terminations. When the ohms read zero, I had found the other end of the cable. I labeled them on both ends of course, because I have a hard time remembering breakfast. 

I have used the capacitor reading on the VOM to check the AC capacitors in place. Do turn off the power, and short the terminals of the cap before doing this. Unhook the connections to get a true reading. 

I have used the ohm reading to check the windings in electrical motors or compressors before tearing out a unit on the suspicion the compressor was bad. 

A common one is to use the voltmeter to see if a charger or alternator is charging a battery bank. Measure with charger off or disabled, then turn on charger, voltage should increase a bit. 

And finally, and this is what Brad Aden posted, but my version. I also had a bizarre HWH control board problem. It went back to them three times, would work for a month or two, then back to wacky behavior. I was checking continuity of fuses on the board, and of course the fuses tested just fine. Only when I tested voltage at both side of the fuse did I discover that the fuse blades had oxidized, and the fuse was only passing about 6 volts instead of 12.

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#2

Great post! I'll add a few tips.
Deoxit is your friend. Use it to clean oxidation off of fuse blades, etc.
Also realize that a wire may test good but when a load is put on the circuit the voltage may drop. Same situation as Richard posted above for fuses. This could also be caused by a bad crimp terminal.
Use these ferrules on wire ends wherever there might be flex: https://www.amazon.com/Ferrule-Crimping-...110&sr=1-4

Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486 

1993 Newell 39' #337 
Reply
#3

Amen to Deoxit! Absolutely amazing product, I fixed a few computers that would have ended up in the trash with it. Pricey but good stuff.

1999 45'  #504 "Magnolia"
Gravette, Arkansas
1996 40 XL Prevost Marathon 
Reply
#4

Great reminder.

I highly recommend these for the 50 amp plug. https://www.amazon.com/Baomain-AWG-16mm%...108&sr=1-5

Getting the internals tight and keeping them tight inside the 50 amp plug can be a challenge. Placing the AWG 6 wire inside the ferrule keeps the wire from squishing out of the connection when you tighten it down.

Checking the internal connection on the 50 amp plug is on my yearly check list.

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)