You are not logged in or registered. Please login or register to use the full functionality of this board...


question about what temp you need to run engine preheat on series 60
#6

an update.

i found an air leak on the davco 382 fuel processor in the engine compartment. mine has a black plastic ring holding the bottom plate on similar to the black ring holding the clear chamber that the filter goes in.

i took it all apart and went to freightliner and got a new o ring for it. put it back together and primed it.

it took about 2 minutes of cranking to get it started then i let it run for about ten minutes. (long enough to have the guy across the row get a little annoyed that i woke him up from a nap at 1pm).

then it started and stopped repeatedly.

i will see how it does in the morning but i think that air leak was my issue.

i hope so anyway. we are planning on leaving in the morning to drive to st george utah.

tom

2002 45'8" Newell Coach 608  Series 60 DDEC4/Allison World 6 Speed HD4000MH

Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)