09-01-2012, 04:42 PM
Tom that is the adjustment. Mark it before u move it then try to back it up a bit They do have resistantance when adjusting. But one wonders why the drop? Ground problems??
(09-01-2012, 11:37 AM)encantotom Wrote: ok, cooled off some so went out to play with the newell.
the voltage is reading 12.8v. both on the vmspc and the gauge on the dash is close to that as well.
the voltage regulator has an adjustment screw on it. before i break something i need some info.
it shows a direction arrow to increase the voltage. but it has a allen screw cap there.
so, do i remove that allen screw to get at an ajustment screw or is that the adjustment screw? i didnt want to break it as the first impulse is just to start turning it. i tired a little and it was hard to turn.
anyone know
thanks
tom
Jimmy