07-22-2016, 09:53 AM
The capacitor was replaced with the new compressor and dryer. I pulled the unit out of the bay and checked the play on the shaft and there seems to be none and it does spin easily. So tried again to run the unit checking the amperage. The amperage rating on the motor specs 2.35 and it was actually pulling 3.0. Not sure if that much higher makes a difference, anyone know about that?
In about 5 minutes of run time the motor gets up to 135 degrees and just cuts off with no increase in amp draw.
The stuff on the shaft could have been done at newell in an attempt to just try something. I don't see this on the other units.
In about 5 minutes of run time the motor gets up to 135 degrees and just cuts off with no increase in amp draw.
The stuff on the shaft could have been done at newell in an attempt to just try something. I don't see this on the other units.
1988 40 ft 8v92 newell
Coach name Big Blue
25 ft Haulmark car hauler with Andersen Anti sway
2012 Toyota FJ Cruiser.