07-05-2016, 08:06 AM
Jim,
I flattened my home made tip in the vise. It was just standard 6" diameter exhaust tubing with a 45 in the middle.
It was an inexpensive experiment. I did find 6" chrome plated exhaust tubing that I will use next time, and just cut it off with a grinder. It appears my original was simply that. http://www.truckpipestore.com/6in-45-15x...nds-chrome or something similar. An ID/OD may be a better fit, but the 15" length is needed to get a straight cut across the back at a 45 angle.
I flattened my home made tip in the vise. It was just standard 6" diameter exhaust tubing with a 45 in the middle.
It was an inexpensive experiment. I did find 6" chrome plated exhaust tubing that I will use next time, and just cut it off with a grinder. It appears my original was simply that. http://www.truckpipestore.com/6in-45-15x...nds-chrome or something similar. An ID/OD may be a better fit, but the 15" length is needed to get a straight cut across the back at a 45 angle.
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)