[Land Yacht]

I think that was my thread!  What happened to me is the entire assembly pushed back through the dash due to the very limited number of threads exposed for the nut to hold it on.  My solution, which has worked since then, was to use a thread locker on the nut and get it good and tight.  Is that your issue too?   Russ

Russ, that is my issue. When I read your post, I just tucked that info away. When it happened, I remembered your thread and I was not worried. Just took me a minute how to get reverse pressure to release the brake

I have not tried to get the handle off yet, hoping for a reply to tell me how to do it. If it is just a pin, does it push through? What holds the pin in?

Hopefully, the same solution works for me ...
Thanks