04-24-2019, 02:44 PM
I went out and pulled the slide in about 1/3, tried to push up on the radius trim but no movement at all. What I did observe was the front pin was really leaking badly while the HWH light was on and stopped shortly after turning the key off, leaving a mess of fluid to clean up. I then activated the key a second time and pulled the slide all the way in and turned the key off, again the leaking started and stopped, however the pin never engaged nor did the rear one. I am not sure how they are connected and I wonder if because of the front leak if the rear is not getting enough pressure?? Attached are two pictures, the first is the front pin and second the rear. The rear appears to be totally dry. I plan on calling both Newell and HWH tomorrow.
Thanks
Dario Perini
2001 #581
Thanks
Dario Perini
2001 #581