[Glenn and Laureen]

After the 5 day freeze in Austin, Laureen and I recently discovered that we have a couple of leaks in our water bay lines. I had gambled that I would not need to drain the pipes this winter here in Central Texas but the unusually cold spell proved me wrong. The electricity went off at our storage site (causing the elec heater in the water bay to go off), which created 2 problems. (1) One of the check valves in the outlet line from the water pump developed a crack. I can replace it once I figure out how to get the various manifold parts taken apart.

(2) The other issue is that there is a hole in a metal "box" farther down the same line. I don't know what to call the box but a couple of water lines pass through it. The hole is kind of ragged and about 1/4 inch by 1" inch. I have attached a photo. The hole in question is right below the gauge in the photo. The question is whether or not to use JB Weld WaterWeld to patch this hole as a temporary fix until I have more time to replace the unit. Is there a different product you would recommend?

I will take what appears to be the cover off the box later this week and see what it looks like inside.