04-29-2021, 06:00 AM
Hi Jessie, In 13 years of AH repair, I have seen 2 broken eye bolts. Drilling the out with a carbide bit is the only way to remove them. It takes a very good bit, not hardware store special. I have never been able to line up a punch either.
When tightening up the eye bolt, the torque spec is 20 inch-pounds. This is just snug for most men, NOT tight. If you break off the aluminum ears on the burner, you get ot take the burner completely apart to reloace that houing.
When tightening up the eye bolt, the torque spec is 20 inch-pounds. This is just snug for most men, NOT tight. If you break off the aluminum ears on the burner, you get ot take the burner completely apart to reloace that houing.
Rudy Legett
2003 Foretravel U320 4010
ISM11 450 hp Allison 4000R
Factory Authorized Aqua Hot Repair Center
Southeast Texas Area