[BusNit]

While I was doing some cleaning up under the bus, I pressed against a hose and heard air escaping. There is a line that goes from the aux air tank manifold at the rear of the coach and to the shifter. I am not sure why they have a rubber line tied into the hose. Can I just have a new hose made in one piece and skip the short rubber section? I was thinking braided stainless. There is space behind the shifter module but the only way to remove/install the hose is by removing the shifter from the transmission. I had to cut off one bolt for removal. Either way, I always replace hardware. What is the consensus of going with a one piece hose?