[whatsnewell]

OK....was out site seeing today, but just got back and saw Tom's post, etc. In the first picture in my first post the right bottom pin, right top pin and the left top in all have power all the time (when the ignition is on) before the turn signal is initiated. When I initiate the turn signal the right bottom pin power goes on and off, and the left top should begin to do the same thing, and, of course the relay should start clicking. The right top pin stays constant with power in both scenarios. The two center pins seem to be grounds....there is no power to them on any of the three relays.

My question is which is the trigger wire? I'm guessing the right bottom as it has a signal and the left top does not, and based on my conversation with Tom we think this relay is set up in the open position. I'm still a little fuzzy on this so any observations will be appreciated.