You are not logged in or registered. Please login or register to use the full functionality of this board...


Removing center console (doghouse)
#1

I'm installing new flooring & having a difficult time remove the doghouse. I've removed 3 screws that hold it down in the center. I don't think it is attached to the dash?

Any help will be appreciated.

Thanks

Gordon
1991 41.5' #266
8V92 DDEC II
Reply
#2

it may be installed to the front firewall

Ernie Ekberg
Bluebird Wanderlodge
Reply
#3

Gordon.

Can you post a pic? On coach 390 there were at least six screws holding it to the floor and screws hidden behind the console hinge that screwed the doghouse to the dash. IIRC I had to remove the. ConSole cover to access the screws

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#4

    Richard,
Good hearing from you. I've attached 3 pictures, one of the console & 2&3 of where I found the 3 screws. The right side seams attached at the floor but not where it is close to the dash by the glove compartment door. The left side is rock solid just below the dash. There is a piece of wood that hold the bracket for the panel that goes behind the throttle. The screws that retain that peice of wood to the doghouse MAY go throught the doghouse, but not sure yet

I'll advise when I get them out

Thanks again



   


Attached Files Thumbnail(s)
       

Gordon
1991 41.5' #266
8V92 DDEC II
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)