You are not logged in or registered. Please login or register to use the full functionality of this board...


Water Pressure Gauge
#2

Looking at the shape of the meniscus it is probably a glycerin or silicone filled gauge. These are better since they keep contamination (lime scaling) out of the gauge innards. Any gauge with the same fitting, probably 1/4" MNPT would work. But before you buy one pull this one out and make sure the tiny orifice is not scaled over. If it is just clean it off and try it again. Usually when they go bad you'll see some corrosion inside the gauge or the needle will fall off.

Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486 

1993 Newell 39' #337 
Reply


Messages In This Thread
Water Pressure Gauge - by bikestuff - 05-10-2014, 07:58 AM
RE: Water Pressure Gauge - by folivier - 05-10-2014, 08:05 AM
RE: Water Pressure Gauge - by bikestuff - 05-10-2014, 09:11 AM
RE: Water Pressure Gauge - by lbrachfe - 05-10-2014, 05:24 PM
RE: Water Pressure Gauge - by ashley - 05-11-2014, 09:41 AM
RE: Water Pressure Gauge - by bikestuff - 05-12-2014, 12:01 PM
RE: Water Pressure Gauge - by folivier - 05-12-2014, 02:14 PM
RE: Water Pressure Gauge - by Richard - 05-12-2014, 05:21 PM
RE: Water Pressure Gauge - by bikestuff - 05-12-2014, 05:32 PM
RE: Water Pressure Gauge - by Chester Stone - 05-13-2014, 08:40 AM
RE: Water Pressure Gauge - by bikestuff - 05-13-2014, 10:52 AM
RE: Water Pressure Gauge - by encantotom - 05-13-2014, 01:06 PM
RE: Water Pressure Gauge - by Chester Stone - 05-13-2014, 04:45 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)