You are not logged in or registered. Please login or register to use the full functionality of this board...


adjust Detroit valves
#10

(09-02-2012, 10:59 AM)rheavn Wrote:  To give you further idea of what you are looking for, my floor hatch is 23 1/2" X 38 1/2". The access hole behind the center firewall section was approx 23 1/2" X 10" tall.
Had the top end tune up done and transmission service at a Detroit allusion dealer for a total of $1350. Labor was 700 and the rest was parts and tax, Have not really got to drive much but the valves were out some. Had about 100K miles since this had been done. I remove the floor and thought that they would do the tune up for 400 but they had to charge 200 more for a guy to help turn the engine over from the outside. They would not let me out of the coach in the shop. The Transmission was leaking at the internal filter so I just went ahead had a complete serviced. Hope this hold for a while.

1996 #422 and 2004 #689 with YELLOW Goldwing, BMW K1200S, RZR, Dodge Truck

Reply


Messages In This Thread
adjust Detroit valves - by Chester Stone - 09-01-2012, 10:22 AM
RE: adjust Detroit valves - by rheavn - 09-01-2012, 11:02 AM
RE: adjust Detroit valves - by encantotom - 09-01-2012, 11:26 AM
RE: adjust Detroit valves - by Chester Stone - 09-01-2012, 01:15 PM
RE: adjust Detroit valves - by rheavn - 09-01-2012, 03:54 PM
RE: adjust Detroit valves - by rheavn - 09-02-2012, 05:09 AM
RE: adjust Detroit valves - by Chester Stone - 09-02-2012, 08:56 AM
RE: adjust Detroit valves - by rheavn - 09-02-2012, 09:20 AM
RE: adjust Detroit valves - by rheavn - 09-02-2012, 10:59 AM
RE: adjust Detroit valves - by ron skeen - 10-31-2012, 03:58 PM
RE: adjust Detroit valves - by Chester Stone - 11-01-2012, 08:19 AM
RE: adjust Detroit valves - by ron skeen - 11-01-2012, 10:50 AM
RE: adjust Detroit valves - by Chester Stone - 11-01-2012, 12:05 PM
RE: adjust Detroit valves - by ron skeen - 11-01-2012, 03:03 PM
RE: adjust Detroit valves - by Chester Stone - 11-03-2012, 12:19 PM
RE: adjust Detroit valves - by ron skeen - 11-03-2012, 03:10 PM
RE: adjust Detroit valves - by Chester Stone - 11-05-2012, 09:38 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)